Tweco 9-8224 Manuale Utente Scaricare il pdf

Manual 0-2926 1

General Information

The Ohmic Clip is an available option for use only with a Ma-

chine 1Torch™ on automated systems. The system must have

a 'touch the plate' (workpiece) circuit control.

To use this clip the torch must have Shield Cup Body and

Shield Cap installed.

When the shield cap of the torch contacts the workpiece the

system senses the change through the Ohmic Clip. This causes

the torch to retract to the correct preset pierce height from the

workpiece.

Parts Supplied

The following parts are included in this kit:

• OhmicClip-1ea

• InstructionSheet

Installation

1. Turn OFF the power supply.

2. Disconnect the main input power to the power supply.

3. Locate the two slots on each side of the torch head.

4. With the stem of the clip pointing down, slide the Ohmic

Clip onto the torch head. Make sure the tabs on the clip

are seated into the slots on each side of the torch head. The

bottom end of the clip should make contact with the shield

cap.

5. Connect the signal wire, touch the plate, from the customer's

controller to the tab on the top of the clip. The signal wire

can be soldered to the tab or connected with a connector.

6. InstallthepropertorchconsumablesforthePowerSupply

amperage. The Ohmic Clip doesn't need to be removed to

change consumables.

7. ReconnectinputpowertothePowerSupplyandturnON

the unit.

8. Set proper gas pressure or ﬂow.

9. Test torch for proper operation.

Ohmic Clip

Catalog # 9-8224

Installation Instructions

A-03421

Touch The Plate

Signal Wire

Ohmic Clip

Shield Cap

A-03420

Shield

Cup Body

OriginalPublicationDate:2005 Manualno.:0-2926

RevisionDate:3/18/2014   Revision:AD

1 2 3 4

Sommario

Pagina 1 - Catalog # 9-8224

Manual 0-2926 1General InformationThe Ohmic Clip is an available option for use only with a Ma-chine 1Torch™ on automated systems. The system mus

Pagina 2 - 2 Manual 0-2926

2 Manual 0-2926NOTEEveryefforthasbeenmadetoprovidecompleteandaccurateinformationinthismanual.However,thepublisher does not assume

Pagina 3 - Bague de serrage Ohmique

Manuel 0-2926 3Informations GénéralesLa bague de serrage ohmique est une option disponible pour l’usage seulement avec une machine 1Torch™ sur les

Pagina 4 - REMARQUE

REMARQUETout effort a été fait de fournir des informations complètes et précises en ce manuel. Cependant, l’éditeur n’assume et ne dément par ceci auc

Commenti su questo manuale

Nessun commento

Tweco 9-8224 Manuale Utente

Navigare online o scaricare Manuale Utente per Hardware Tweco 9-8224. Tweco 9-8224 Manuel d&#039;utilisation [ru] Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Tweco 9-8224

Navigare online o scaricare Manuale Utente per Hardware Tweco 9-8224. Tweco 9-8224 Manuel d'utilisation [ru] Manuale Utente